Industry news
DTF Printer：When the nozzle test is good,white is very light when printing ,what do i need to do to increase it?
2025-05-26
Preparation:Cut off the power supply of the printer
STEP1:First shake the white ink tank.Note: When shaking the ink tank, you should block the air valve with your hand to prevent the ink from overflowing and wetting the circuit.
STEP2:Confirm whether the two knobs are adjusted to 50
STEP3:Setting up on the PrintExp,load ink 15 seconds, weak clean three times, and nozzle test
STEP4:After all three are done, set the spot according to the customer's suggestion，however, it is generally not recommended to increase the white density value in the spot setting, as it will put a great burden on the print head.
Usually the white density will change in the above cases.
STEP1:First shake the white ink tank.Note: When shaking the ink tank, you should block the air valve with your hand to prevent the ink from overflowing and wetting the circuit.
STEP2:Confirm whether the two knobs are adjusted to 50
STEP3:Setting up on the PrintExp,load ink 15 seconds, weak clean three times, and nozzle test
STEP4:After all three are done, set the spot according to the customer's suggestion，however, it is generally not recommended to increase the white density value in the spot setting, as it will put a great burden on the print head.
Usually the white density will change in the above cases.